CC-BY Applied Ergonomics, 2021, March https://www.journals.elsevier.com/applied-ergonomics Purpose: To analyze progression of changes in kinematics and work physiology during progressive lifting in healthy adults.Methods: Healthy participants were recruited. A standardized lifting test from the WorkWell …

The potential benefits of using redundant controls on a compound helicopter for manoeuvre load alleviation whilst optimizing handling qualities are investigated. The research is focused on forward flight lateral (roll) manoeuvres and hub loads. The main control effectors of interest are the ailerons …

Wind turbines are usually clustered in wind farms which causes the downstream turbines to operate in the turbulent wakes of upstream turbines. As turbulence is directly related to increased fatigue loads, knowledge of the turbulence in the wake and its evolution are important. Therefore, the main objective …

In the following thesis, research is conducted on the effect of sea-level rise and expected hydraulic load levels for the Scheldt Estuary, currently and in the future. As climate changes advances and the sea-level rises, insight into the effects of the rise on our coastal area's is essential. Rijkswaterstaat …

The Nieuw Statendam is equipped with a program called ENIRAM. This program calculates the optimal engine configuration and load expressed in revolutions per minute of the propellers. The issue with this program is that it only looks at the main power plants and does not take the waste heat recovery system …

Dynamic stall phenomena carry the risk of negative damping and instability in wind turbine blades. It is crucial to model these phenomena accurately to reduce inaccuracies in predicting design driving (fatigue and extreme) loads. Some of the inaccuracies in current dynamic stall models may be due to …

Horizontal axis wind turbines (HAWTs) experience three-dimensional rotational and unsteady aerodynamic phenomena at the rotor blades sections. These highly unsteady three-dimensional effects have a dramatic impact on the aerodynamic load distributions on the blades, in particular, when they occur at …

Within the Flexnode Plus project the long-term degradation characteristics of a proton exchange membrane (PEM) electrolyzer (5.5 kW, AC, 1 Nm3/h H2) and fuel cell (1.0 kW, DC, 0.9 Nm3/h) was experimentally tested. The electrolyzer unit was operated at various loads and pressures for approximately 750 …

Dynamic stall phenomena bring risk for negative damping and instability in wind turbine blades. It is crucial to model these phenomena accurately to reduce inaccuracies in predicting design driving (fatigue) loads. Inaccuracies in current dynamic stall models may be due to the facts that they are not …

This research proposes new structural lay-outs for large wind turbine blades. The lay-outs were found by an optimisation method where the aerodynamics of wind turbine blades was combined with the structural model of the blade, formulated in a corotational framework. The aeroelastic blade loads were calculated …