Doorgaande ontwikkeling van een model waarmee waterstofketens en –toepassingen ontworpen, geanalyseerd en geoptimaliseerd kunnen worden.

The intermittency of renewable energy technologies requires adequate storage technologies. Hydrogen systems consisting of electrolysers, storage tanks, and fuel cells can be implemented as well as batteries. The requirements of the hydrogen purification unit is missing from literature. We measured the …

Within the Flexnode Plus project the long-term degradation characteristics of a proton exchange membrane (PEM) electrolyzer (5.5 kW, AC, 1 Nm3/h H2) and fuel cell (1.0 kW, DC, 0.9 Nm3/h) was experimentally tested. The electrolyzer unit was operated at various loads and pressures for approximately 750 …

In het kader van het FLEX P2G project zijn prototypes van een 50 KW PEMWE electrolyser en van een SEM reactor ontwikkeld. Met behulp van deze Power to Gas (P2G) technologie kan door middel van elektrolyse eerst waterstof en vervolgens ‐ na een reactie met CO2‐ methaan worden geproduceerd. Dit onderzoek …

This report focuses on the feasibility of the power-to-ammonia concept. Power-to-ammonia uses produced excess renewable electricity to electrolyze water, and then to react the obtained hydrogen with nitrogen, which is obtained through air separation, to produce ammonia. This process may be used as a …

We all need to act now for a sustainable tomorrow.During the K4I (Brussels) lunch debate Hanze UAS PhD level researchers of different nationalities presented their ideas about their EU in 2050 in terms of intrinsic qualities. They discussed how the EU should look in 2050.

Locally produced methane, - either as biomethane or power-to-gas product, has to be stored to provide a reliable gas source for the fluctuating demand of any local gas distribution network. Additionally, methane is a prominent transportation fuel but its suitability for vehicular application depends …