OBJECTIVE: This scoping review aimed to gather current knowledge on accurately identifying and distinguishing between non-frail, pre-frail, and frail older adults using gait and daily physical activity (DPA) parameters and/or models that combine gait with DPA parameters in both controlled and daily life …

Background: Both the Short Physical Performance Battery (SPPB) and daily life gait quality and quantity obtained from wearable sensors are used to measure functional status in older adults. It is generally assumed that they are interrelated and exchangeable, but this has not yet been established. Interchangeability …

The aim of this explorative study was to determine the key inertial measurement unit-based wheelchair mobility performance components during a wheelchair tennis match. A total of 64 wheelchair tennis matches were played by 15 wheelchair tennis players (6 women, 5 men, 4 juniors). All individual tennis …

Wearable inertial sensors (WIS) facilitate the preservation of the athlete-environment relationship by allowing measurement outside the laboratory. WIS systems should be validated for team sports movements before they are used in sports performance and injury prevention research. The aim of the present …

BACKGROUND: Physical activity may be both a risk and protective factor for falls and fall-related fractures. Despite its positive effects on muscle and bone health, physical activity also increases exposure to situations where falls and fractures occur. This paradox could possibly be explained by frailty …

In wheelchair sports, the use of Inertial Measurement Units (IMUs) has proven to be one of the most accessible ways for ambulatory measurement of wheelchair kinematics. A three-IMU configuration, with one IMU attached to the wheelchair frame and two IMUs on each wheel axle, has previously shown accurate …

In sports, inertial measurement units are often used to measure the orientation of human body segments. A Madgwick (MW) filter can be used to obtain accurate inertial measurement unit (IMU) orientation estimates. This filter combines two different orientation estimates by applying a correction of the …

This paper describes a calibration method for inertial and magnetic sensors using a batched optimization procedure. Well estab- lished sensor, motion and constraint models are applied which include sensor gains, biases, misalignments and inter-triad misalignments. For the magnetometer, hard and soft …

Bij Adelante Kenniscentrum wordt onderzoek gedaan naar het gebruik van sensorhandschoen bij revalidatie van patiënten met centraal neurologisch hersenletsel. Hiervoor moet worden uitgezocht of de signalen van een sensorhandschoen betrouwbaar zijn. Daarom is eerst een markonderzoek gedaan naar welke handschoenen …

Traditional IMU based PDR systems suffer from rapidly growing drift effects due to the inherent bias of the inertial sensor. Many existing solutions to mitigate this problem use aiding sensors or information as heuristics or map data. We propose a new optimization framework to solve the PDR estimation problem …