De grootste kennisbank van het HBO

Inspiratie op jouw vakgebied

Vrij toegankelijk

Terug naar zoekresultatenDeel deze publicatie

Digital printing of μPlasmas to selectively improve wetting behavior of functional inks for printed electronics

Rechten: Alle rechten voorbehouden

Digital printing of μPlasmas to selectively improve wetting behavior of functional inks for printed electronics

Rechten: Alle rechten voorbehouden

Samenvatting

In this article we investigate the change in wetting behavior of inkjet printed materials on either hydrophilic or hydrophobic plasma treated patterns, to determine the minimum obtainable track width using selective patterned μPlasma printing. For Hexamethyl-Disiloxane (HMDSO)/N2 plasma, a decrease in surface energy of approx. 44 mN/m was measured. This resulted in a change in contact angle for water from <10 up to 105 degrees, and from 32 up to 46 degrees for Diethyleneglycol-Dimethaclylate (DEGDMA). For both the nitrogen, air and HMDSO/N2 plasma single pixel wide track widths of approx. 320 μm were measured at a plasma print height of 50 μm. Combining hydrophilic pretreatment of the glass substrate, by UV/Ozone or air μPlasma printing, with hydrophobic HMDSO/N2 plasma, the smallest hydrophilic area found was in the order of 300 μm as well.

OrganisatieFontys
AfdelingFontys Hogeschool Toegepaste Natuurwetenschappen
LectoraatLectoraat Thin films and functional materials
Jaar2012
TypeConferentiebijdrage
ISBN978-0-89208-302-2
TaalEngels

Op de HBO Kennisbank vind je publicaties van 26 hogescholen

De grootste kennisbank van het HBO

Inspiratie op jouw vakgebied

Vrij toegankelijk