The Amsterdam Sensor Lab is part of the Amsterdam University of Applied Sciences (AUAS) and its goal is to develop application specific sensor systems for applied research. In order to (anonymously) measure, for instance, traffic without influencing people’s behaviour, a pressure sensing sub-tile is …

With sufficient electrical energy CO2 from the atmosphere, combined with water, can be converted to hydrocarbons. The first step in converting CO2 into a carbon based fuel is the dissociation of CO2 into CO and O. DIFFER explores the possibilities of this process by using a microwave plasma. This project …

Maintaining independence is the most important goal of the majority of older people. The onset of disability in activities of daily living is one of the greatest threats to the ability of older people to live independently. Older people with a low socioeconomic status (SES) are at high risk of functional …

Kinematical joint analysis during road cycling is a new trend. Reviewing the methods for 2D and 3D lower limb kinematical research, the sensor to segment alignment appeared to be the most challenging part due to unknown orientation with respect to the anatomical joints. A methodology that is suitable …

This paper describes the robustness determination and optimization of L-cysteine addition for total mercury content determination by Instrumental Neutron Activation Analysis (INAA). Instrumental Neutron Activation Analysis is an analysis technique to measure concentrations of chemical elements regardless …

Introduction: Body composition and body circumferences are tools for health professionals to predict health risks and to evaluate a patient’s treatment. The BODPOD® is a validated device to determine body composition, but it is expensive and therefore not accessible for a lot of health professionals. …

Gas-phase diffusion is a widespread process in nature, for example diffusion of pollutants in the atmosphere. A special case of diffusion is the so-called Knudsen diffusion where a gas diffuses in the molecular flow regime. The theory for Knudsen diffusion is well-known therefore, diffusion experiments …

Op verzoek van Jelle Scheurleer: Purpose: To investigate the accuracy of dose calculation on cone beam CT (CBCT) data sets after HU-RED calibration and validation in phantom studies and clinical patients. Material and methods: Calibration of HU-RED curves for kV-CBCT were generated for three clinical …

Dit rapport focust op het kiezen, ontwerpen, realiseren en uiteindelijk testen van een analysemethode die de verspreiding van houtskool in een cold flow wervelbed (verbrandingskamer) kan bepalen. Deze coldflow opstelling is een simulatie van MILENA met 22MW thermische input. Tijdens dit afstudeerproject …

A Quad Focus GridPix Gaseous Tracking Detector is under construction, to allow calibration and test beam measurements to validate the working principles of the (quad) GridPix detectors while using a focused electric field. The development is well on its way: both measurements should be able to be conducted …